Brushed / Brushless DC motor Driver

1. Voltage range: DC6V – 28V
2. Current range: Within 3A
3. Switch function: None
4. Speed range: 0-100%
5. Dimension: 65 x 30 x 15mm
6. Weight: 25 g

1. Input voltage: DC12 to 36V (equal to the rated voltage of the motor)
2. Output voltage: linear under load
3. Maximum current: 50A
4. Continuous current: 40A
5. Speed regulation mode: potentiometer (linear)
6. Support motor: DC brush motor

1. Model: CCM6DS
2. High-Quality Construction
3. Input Voltage: 12 to 50VDC
4. Output Current: 30A (max)

1. Adjustable speed range: 0%-100%.
2. Speed adjustment way: Potentiometer.
3. Output voltage: Linear under load.
4. Speed control type: Basins.
5. Output voltage: Load Linear
6. Type: Adjusting flow
7. The motor running condition adjustment: Forward  / Stop / Reverse

1. Model: BLD300
2. Input voltage: +18 to+50VDC
3. Rated (RPM): 0-20000
4. Weight: 306g

1. Model: BLD750
2. Input voltage: 15~52 VDC
3. Rated (RPM): 0-20000

The MD10-POT control circuit is designed to enable the speed to be controlled via a potentiometer (10K Ohm) which is included in the package. It does not work with analog voltage from an external controller  The 3-way rocker switch is used for start/stop and direction control.

1. Operating Voltage: DC 7 V to 30 V
2. Maximum Motor Current: 10 A continuous, 30 A peak
3. Motor Output PWM Frequency: 20 kHz
4. RC Input Voltage (RC1 & RC2): Low Level: 0-0.7 V | High Level: 1.5-15 V
5. Output Maximum Current: 0-500 mA

1. Bi-directional control for 1 brushed DC motor, single channel
2. Support motor voltage ranges from  5V to 30V.
3. Maximum current up to 13A continuous and 30A peak (10 seconds).
4. 3.3V and 5V logic level input.
5. Solid state components provide faster response time and eliminate the wear and tear of the mechanical relay.
6. Fully NMOS H-Bridge for better efficiency and no heat sink is required.

1. Industrial grade PCB.
2. Vmotor: 7 V to 25 V DC.
3. Each component is soldered properly and tested.
4. Able to drive 4 DC motor at 2.5A (peak), 1.5A continuously.
5. 2 LEDs as a direction indicator for each motor.
6. 1 LED as a power indicator.
7. A pluggable connector for more user-friendly design.
8. Fully compatible with Cytron DIY project, Flexibot – Using Transwheel (PR19).

1. Battery low voltage indicator.
2. Battery over voltage indicator.
3. Thermal protection.
4. Current limit protection.
5. Bi-directional control for dual brushed DC motor.
6. Support motor voltage from 7V to 35VDC.
7. Dimension: 103 x 97 x 40 (LxWxH) mm.

1. Single power operation
2. Dual Channels means it can drive two brush motor independently, or mixed.
3. Support Signed magnitude and Locked Anti-phase in PWM mode.
4. Two manual/test buttons for each channel.
5. Two output indicator LEDs for each channel.
6. Power, Error indicator, RUN status (Left and Right) LEDs
7. On board reset button to restart the MCU after changing operation mode.
8. Operating modes: RC (RC servo signal), Analog, PWM, simplified and packetized UART.