- Bi-directional control of 1 brushed DC motor.
- Support motor voltage ranges from 7V to 25V, .
- Maximum current up to 10A continuous and 15A peak (10 seconds).
- Solid state components provide faster response time and eliminate the wear and tear of a mechanical relay.
- Fully NMOS H-Bridge for better efficiency and no heat sink is required.
- Speed control PWM frequency up to 10KHz.
- Selectable digital pins for PWM and DIR.
-18%
Development Boards
10A Motor Driver Shield – MD10
- Bi-directional control of 1 brushed DC motor.
- Support motor voltage ranges from 7V to 25V, .
- Maximum current up to 10A continuous and 15A peak (10 seconds).
- Solid state components provide faster response time and eliminate the wear and tear of a mechanical relay.
- Fully NMOS H-Bridge for better efficiency and no heat sink is required.
- Speed control PWM frequency up to 10KHz.
- Selectable digital pins for PWM and DIR.
₹1,773.00 ₹2,173.00
Related products
-
Development Boards
AEROKART INDIA Breadboard 840 point with jumper wires Set (20+20+20)
- Comes with 840 tie points: 128 groups of 5 connected terminals, 8 bus of 25 connected terminals
- Reusable for fast build a prototype of an electronic circuit will accept transistors, diodes, leds, resistors, capacitors and virtually all types of components
- Each cable length about 20cm
- Can modify or revise the circuits easily
- The male ends meant for insertion into standard 0.1 inch (2.54mm) female sockets and the female ends are meant for insertion onto standard 0.1 inch (2.54mm) male headers
SKU: n/a -
Development Boards, Original Arduino Boards and Shields
Arduino MKR Vidor 4000
- FPGA: Intel® Cyclone® 10CL016
- PCI: Mini PCI Express port with programmable pins
- Camera Connector: MIPI camera connector
- Microcontroller: SAMD21 Cortex®-M0+ 32bit low power ARM MCU
- Radio module: u-Blox NINA-W102 (datasheet)
- Board Power Supply :(USB/VIN) 5V
- All pins are PWM pins
- MIPI camera connector
- Mini PCI Express port with programmable pins
- Full-Speed USB Device and embedded Host
SKU: n/a
Reviews
There are no reviews yet