Rotary Encoder
Showing 1–24 of 25 results
-
Sensors
Correlation Photoelectric Infrared Count Slot Sensor Module 10 mm
- The width of the optical coupling slot: 10mm
- Single signal output.
- The circuit board output switch!
- The output valid signal is low.
- Can be used for workpiece counts.
- It can also be used for industry counting, motor speed testing.
SKU: n/a -
Sensors
Correlation Photoelectric Infrared Count Slot Sensor Module 5 mm
- The width of the optical coupling slot: 5mm
- Single signal output.
- The circuit board output switch!
- The output valid signal is low.
- Can be used for workpiece counts.
- It can also be used for industry counting, motor speed testing.
SKU: n/a -
-
-
-
Sensors
OE-775 Hall Effect Two Channel Magnetic Encoder(Color may vary )
This encoder is featured and developed for the series of Orange planetary DC gear motors. The encoder are tested for its precise output and robustness in all electronic as well as environmental parameters listed. So If you wish to add feedback to older or new gear motors this encoder will do the trick as long as your Motor has a long back shaft.
SKU: n/a -
-
Sensors
Orange 1000 PPR 2-Phase Incremental Optical Rotary Encoder with Outer diameter 41mm
- Encoder Type: Optical
- IP52 (IEC Standard) Protection
- Stainless Steel Shaft
- High-quality 2-Meter Cable
- Anti-jamming Performance
- 2-Phase precise Output Readings
- Small size, Lightweight for Easy Installation
SKU: n/a -
-
-
-
-
-
-
-
-
-
Sensors
Speed Measuring Sensor Groove Coupler Module For Arduino
- Using imported groove optical coupling sensor, width 5mm.
- It has the output state light, if output high level, the lights are off. if output low level, it on.
- If it covered, it will output high level; otherwise, its output low level.
- Good signal and waveform, with a strong driving ability for more than 15mA.
- Equipped with a fixed bolt hole, easy install.
- Use the LM393 wide voltage comparer.
SKU: n/a
