- Microcontroller: ATmega168 or ATmega328V
- Operating Voltage: 2.7-5.5 V
- Digital I/O Pins: 14
- PWM Channels: 6
- Analog Input Channels: 6
- DC Current per I/O Pin: 40 mA
- Board will run from 2V to 5V.
- The latest version of the LilyPad supports automatic reset for even easier programming.
- The back side of the LilyPad is now completely flat!
-10%
Development Boards
LilyPad 328 ATmega328P Main Board 16M Compatible with Arduino
- Microcontroller: ATmega168 or ATmega328V
- Operating Voltage: 2.7-5.5 V
- Digital I/O Pins: 14
- PWM Channels: 6
- Analog Input Channels: 6
- DC Current per I/O Pin: 40 mA
- Board will run from 2V to 5V.
- The latest version of the LilyPad supports automatic reset for even easier programming.
- The back side of the LilyPad is now completely flat!
₹929.00 ₹1,029.00
Based on 0 reviews
Be the first to review “LilyPad 328 ATmega328P Main Board 16M Compatible with Arduino”
Related products
-
Development Boards
AEROKART INDIA Breadboard 840 point with jumper wires Set (20+20+20)
- Comes with 840 tie points: 128 groups of 5 connected terminals, 8 bus of 25 connected terminals
- Reusable for fast build a prototype of an electronic circuit will accept transistors, diodes, leds, resistors, capacitors and virtually all types of components
- Each cable length about 20cm
- Can modify or revise the circuits easily
- The male ends meant for insertion into standard 0.1 inch (2.54mm) female sockets and the female ends are meant for insertion onto standard 0.1 inch (2.54mm) male headers
SKU: n/a -
Development Boards, Original Arduino Boards and Shields
Arduino MKR Vidor 4000
- FPGA: Intel® Cyclone® 10CL016
- PCI: Mini PCI Express port with programmable pins
- Camera Connector: MIPI camera connector
- Microcontroller: SAMD21 Cortex®-M0+ 32bit low power ARM MCU
- Radio module: u-Blox NINA-W102 (datasheet)
- Board Power Supply :(USB/VIN) 5V
- All pins are PWM pins
- MIPI camera connector
- Mini PCI Express port with programmable pins
- Full-Speed USB Device and embedded Host
SKU: n/a -
Development Boards
STMICROELECTRONICS Development Board, STM32F410RB Nucleo-64 MCU, ST-LINK/V2-1 Debugger/Programmer, Arduino/ST morpho
-20%
Development BoardsSTMICROELECTRONICS Development Board, STM32F410RB Nucleo-64 MCU, ST-LINK/V2-1 Debugger/Programmer, Arduino/ST morpho
- USB VBUS or external source (3.3V, 5V, 7 to 12V) and power management access point
- USB communication (LD1), user LED (LD2), power LED (LD3)
- Two push buttons – USER and RESET
- USB re-enumeration capability – virtual com port, mass storage, debug port
- Supported by wide choice of IDEs including IAR, Keil, GCC-based IDEs
SKU: n/a
There are no reviews yet.