Recommended Products
Raspberry Pi 4 Model-B with 8 GB RAM
Shop
Showing 5305–5328 of 6091 results
-
-
Sensors
Square 10M Float Switch For Industry Pump Tank Sensor
- Product: 10M Float Switch For Industry Pump Tank Sensor
- Rated current/voltage: 10(8A) 250V ~ 10(4A) 380V
- Wire Length:10m
- Protection class: IP68
- Working pressure:0.1MPa
- Operating temperature: 0~75℃
- Electrical life: 1 x 100 000 times
- Mechanical life: 5 x 100 000 times
SKU: n/a -
Sensors
Square 15M Float Switch For Industry Pump Tank Sensor
- Product: 15 M Float Switch For Industry Pump Tank Sensor
- Rated current/voltage: 10(8A) 250V ~ 10(4A) 380V
- Wire Length:15m
- Protection class: IP68
- Working pressure:0.1MPa
- Operating temperature: 0~75℃
- Electrical life: 1 x 100 000 times
- Mechanical life: 5 x 100 000 times
SKU: n/a -
-
Basic Electronic Components, Electronic Components, PCB Adapter
SSOP-48 to DIP-48 SMT Adapter
SSOP-48 (0.635 mm pin pitch) to DIP-48 (600 mil body width, 0.1″ pin pitch) surface mount adapter. Topside of board fits surface mount footprint. A bottom side of PCB has pads for two single row surface mount vertical headers. This board uses surface mount male vertical headers, which are included.
Package Includes:
1 x SSOP-48 to DIP-48 SMT Adapter.
SKU: n/a -
Basic Electronic Components
ST-Link V2 Programmer For STM8 and STM32
ST-Link V2 Programmer For STM8 and STM32
ST-Link V2 Programmer For STM8 and STM32 is fully consistent with the official version, support for automatic upgrades, support the full range STM32 SWD (only 4pins including SWCLK, SWDIO, and power) and a full range STM8 SWIM (only 4pins including SWIM, Reset and power) download and debug.
Use this device to send program code to the 32-bit STM32 ARM Cortex or 8-bit STM8 microcontrollers. The header for this ST-Link v2 programmer contains connections for 5V, 3.3V, SWCLK, SWDIO, SWIM, Reset (RST/NRST) and GND. The connector on the opposite side of this device is a USB connector and is intended to be plugged into the computer
SKU: n/a -
Development Boards
ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32
- 5V power supplied by a USB connector
- USB 2.0 full speed compatible interface
- USB standard A to mini B cable
- 1.65V to 5.5V application voltage supported on SWIM interface
- SWIM low speed and high-speed modes supported
SKU: n/a -
-
-
-
-
-
-
-
-
-
-
-
